Filter
Top Products
Introduction
19
(Continued)
Basic operations
Before playing back video discs, you need to
select the color system and the video processing
system.
NOTE
• Make sure that the main unit is connected with the
TV using a component video cord when you select
the progressive mode ( page 14).
1 Press , and then press
.
2 Hold down for approximately
2 seconds.
• Currently selected color system and the
video processing system appear on the dis-
play window.
3 Press
to select the desired
system.
"PAL PROG ." or "NTSC PROG
." gives finer detailed
images than "PAL" or "NTSC".
4 While the selected system is dis-
played, press .
NOTE
• Some TVs may not be compatible with the progres-
sive mode. In this case, select "PAL" or "NTSC".
• All progressive TVs and High-Definition TVs
manufactured by JVC are compatible with "PAL
PROG." and "NTSC PROG."
• Before playing back a disc, it is also required to
select the correct "MONITOR TYPE" in the "PIC-
TURE" menu according to the aspect ratio of
your TV ( page 40).
• If you play back an NTSC disc with this setting
set to "PAL" or "PAL PROG.", you can watch the
playback pictures (the disc will be reproduced
using "PAL 60" format), but the TV screen may
rolls over upward and downward rapidly.
• If you play back a PAL disc with this setting set to
"NTSC" or "NTSC PROG.", you can watch the
playback pictures, but the following symptoms
may occur:
• The items on the disc menu will be blurred, and
be shown slightly shifted when highlighted.
• The aspect ratio of the picture may differ from
the original aspect ratio.
• The picture movement is not smooth.
For the locations of remote control
buttons, refer to page 16.
Selecting the Color System
and the Video Processing
System (SCAN MODE)
PAL
PAL color system in the interlace
mode is selected.
PAL PROG
.
PAL color system in the progressive
mode is selected. Make sure that the
TV supports PAL progressive video
input ( page 14).
NTSC
NTSC color system in the interlace
mode is selected.
NTSC PROG
.
NTSC color system in the progressive
mode is selected. Make sure that the
TV supports NTSC progressive video
input ( page 14).
UX-QD70[UB]-03.fm Page 19 Monday, September 12, 2005 2:32 PM