Filter
Top Products
57
English
Adding a Track to a Group—ENTRY GR
This function allows you to enter a track into a group. The track will
be added as the last track in the selected group.
The track numbers will be renumbered.
• To stop any time during the editing process below before step
8
,
press GROUP TITLE EDIT.
1
Insert an MD you want to edit into the MD
loading slot.
On the remote control ONLY:
2
Press GROUP TITLE EDIT repeatedly
until “ENTRY GR ?” appears on the
display.
• If you want to stop this editing process, press CANCEL.
3
Press SET.
• During playback:
The currently playing track number starts flashing.
4
Press UP ¢ or DOWN 4 to
select the track.
• You can also select the track using the number buttons. In this
case, the selected track starts playback repeatedly.
5
Press SET.
• If the loaded MD has no group, you cannot go to the following
steps.
• When the selected track belongs to a group, its group number
appears on the display.
• To cancel the setting, press CANCEL, then repeat from step
4
.
6
Press GROUP/TITLE >>
I
or
GROUP/TITLE
I
<< to select the
group.
• The unit plays back all tracks in the selected group repeatedly.
7
Press SET.
• To cancel the setting, press CANCEL, then repeat from step
4
.
8
Press ENTER.
“EDITING” appears and the REC (MD recording)
indicator flashes on the display. Then “WRITING”
flashes while editing you have made is being recorded
on the MD.
When “CANNOT ENTRY!” appears on the display in
step
7
You are trying to enter the selected track into the same group again. Repeat
procedure from step
6
.
Ex.: When track 13 is selected.
Ex.: When group 18 is selected.
Editing an MD (Continued)
EN54-62_UX-J99DVD[UB]5.p65 03.12.12, 11:05 PM57