Filter
Top Products
36
4. Press MEMORY again while the
selected channel number is flashing on
the display.
The selected channel number stops flashing.
The station is assigned to the selected channel number.
5. Repeat steps 1 to 4 until you store all the stations
you want.
To erase a stored preset station
Storing a new station on a used number erases the previously stored
one.
To tune in a preset station
On the front panel:
1. Press FM/AM.
The last received station of the selected band
is tuned in.
• Each time you press the button, the band
alternates between FM and AM.
2. Press FM/AM PRESET 5/∞ until
you find the channel you want.
• Pressing FM/AM PRESET 5 increases the
number.
• Pressing FM/AM PRESET ∞ decreases the
number.
From the remote control:
1. Press FM/AM.
The last received station of the selected band is
tuned in.
• Each time you press the button, the band
alternates between FM and AM.
2. Press the 10 keys to select a preset channel
number.
• For channel number 5,
press 5.
• For channel number 15,
press +10 then 5.
• For channel number 20,
press +10 then 10.
• For channel number 30,
press +10, +10, then 10.
Notes:
• You can only select the same station of the same band (FM or AM)
both for the main room and sub-room operations. If you change the
station for the sub-room, it also changes for the main room (and
vice versa). This also means that if you change the station for the
sub-room while recording a broadcasting program in the main
room, recording in the main room will be interrupted.
• When you use the 10 keys on the remote control, be sure that
“TUNER” appears on the display window on the remote control.
If not, start at step 1.
• The preset number does not appear for the sub-room.
ANALOG
VOLUME
MAIN ROOM
AUTO MUTING TUNED STEREO
L R
SPEAKERS
1
FM/AM
FM MODE
On the front panel
MEMORY
FM/AM
FM MODE
0
L—BALANCE—R
EFFECT
CENTER ROOM SIZESUBWFR
REAR·L
DIGITAL EQ
FM MODE
RETURN
100
+
CENTER TONE
REAR·R LIVENESS
123
456
7
/P 89
10
+
100
Selecting the FM Reception Mode
When an FM stereo broadcast is hard to
receive or noisy
You can change the FM reception mode while receiving an FM
broadcast.
• You can store the FM reception mode for each preset station.
Press FM MODE.
• Each time you press the button, the FM reception mode alternates
between “AUTOMUTING” and “MONO.”
AUTOMUTING: When a program is broadcasted in stereo, you
will hear stereo sound; when in monaural, you will
hear monaural sounds. This mode is also useful to
suppress static noise between stations. The AUTO
MUTING indicator lights on the display.
MONO: Reception will be improved although you will lose the
stereo effect. In this mode, you will hear noise while
tuning into the stations. The AUTO MUTING and
STEREO indicator go off from the display.
Note:
Before you use the FM MODE button on the remote control, press
FM/AM on the remote control to set the mode of the remote control to
“TUNER.”
FM/AM PRESET
From the remote control
ANALOG
VOLUME
MAIN ROOM
AUTO MUTING TUNED STEREO
L R
SPEAKERS
1
ANALOG
VOLUME
MAIN ROOM
TUNED
L R
SPEAKERS
1
EN27-36.RX-9010VBK[J]f 01.2.15, 0:15 PM36