Filter
Top Products
28
From the remote control:
1. Press SOUND.
The 10 keys are activated for sound adjustments.
2. Press BALANCE R or BALANCE L to adjust the
balance.
• Pressing BALANCE R decreases the left
channel output (from R –21 to CENTER,
from CENTER to L –21).
• Pressing BALANCE L decreases the right
channel output (from L –21 to CENTER, from CENTER to R
–21).
Note:
This function is applied only to the main room sources.
Setting the Subwoofer Information
Register whether you have connected a subwoofer or not.
Before you start, remember....
• There is a time limit in doing the following steps. If the setting is
canceled before you finish, start from step 1 again.
On the front panel ONLY:
1. Press SETTING repeatedly until
“SUBWOOFER” appears on the
display.
The display changes to show the current setting.
2. Press CONTROL UP 5/DOWN ∞
to select “YES” or “NO.”
• Each time you press the button, the display
alternates between “YES” and “NO.”
YES: Select this when a subwoofer is connected.
NO: Select this when no subwoofer is used.
Note:
You cannot use SUBWOOFER OUT ON/OFF on the front panel (see
page 21) and adjust the subwoofer output level (see to the right) when
“SUBWOOFER” is set to “NO.”
SOUND
Adjusting the Subwoofer Output Level
You can adjust the subwoofer output level if you have selected
“YES” for the “SUBWOOFER” (see to the left).
• You can do this setting for each source.
Before you start, remember....
• There is a time limit in doing the following steps. If the setting is
canceled before you finish, start from step 1 again.
• When the front speakers are all deactivated, the subwoofer level
cannot be adjusted.
On the front panel:
1. Press LEVEL ADJUST repeatedly
until “SUBWFR” appears on the
display.
The display changes to show the current
setting.
2. Press CONTROL UP 5/DOWN ∞
to adjust the subwoofer output
level (from –20 dB to +10 dB).
From the remote control:
1. Press SOUND.
The 10 keys are activated for sound
adjustments.
2. Press SUBWFR.
3. Press LEVEL + or LEVEL – to adjust the
subwoofer output level from –20 dB to + 10 dB.
• Each time you press the button, “S WFR”
appears on the display on the remote
control.
SETTING
LEVEL
ADJUST
CONTROL
DOWN UP
SOUND
SUBWFR
5
LEVEL+
LEVEL–
L—BALANCE—R
12
CONTROL
DOWN UP
EN27-36.RX-9010VBK[J]f 01.2.15, 0:15 PM28