Filter
Top Products
– 7 –
English
RIGHT
LEFT
CAUTION:
SPEAKER IMPEDANCE
6~16 OHMS
SPEAKERS
342
1
3
2
ANTENNA
FM
AM LOOP
FM
75
GND
GND
AM
EXT
1
AM antenna
Connecting Speakers
You can connect a pair of the front speakers.
Right
speaker
Left
speaker
Black
Red
1 If cords are covered with insulation, twist the
core of the cord at the end of each cord, then
remove the insulation.
2 Press and hold the clamp of the speaker
terminal on the rear of the unit.
3 Insert the end of the speaker cord into the
terminal.
Match the polarity of the speaker terminals: Red (+) to
red (+) and black (–) to black (–).
4 Release the finger from the clamp.
IMPORTANT: Use only speakers with the same speaker
impedance as indicated by the speaker terminals on the
rear of the unit.
Speaker
cord
Speaker
cord
1 If cords are covered with insulation, twist the
core of the cord at the end of each cord, then
remove the insulation.
2 Connect the AM loop antenna to the AM
LOOP terminals as illustrated.
3 Turn the AM loop antenna until you have the
best reception.
To connect an outdoor AM antenna
When reception is poor, connect a single vinyl-covered wire
to the AM EXT terminal and extend it horizontally. (The AM
loop antenna must remain connected.)
For better reception of both FM and AM
• Make sure the antenna conductors do not touch any other
terminals and connecting cords.
• Keep the antennas away from metallic parts of the unit,
connecting cords, and the AC power cord.
Vinyl-covered wire
(not supplied)
AM loop antenna
(supplied)
MX-J270V[US,UX]01-11 EN/f 00.7.21, 11:32 AM7