Filter
Top Products
27
English
7
Crossover frequency—CROSS OVER
When you use a subwoofer, you can select the cutoff frequency
for the small speakers used.
Select one of the crossover frequency levels according to the
size of the small speaker connected.
80Hz: Select when the cone speaker unit built in the speaker is
about 12 cm.
100Hz: Select when the cone speaker unit built in the speaker is
about 10 cm.
120Hz: Select when the cone speaker unit built in the speaker is
about 8 cm.
150Hz: Select when the cone speaker unit built in the speaker is
about 6 cm.
Notes:
.• If you have selected “LARGE” for all activated speakers (see
page 25), this function is fixed to “OFF.”
• Crossover frequency is not valid for the DVD MULTI playback,
All Channel Stereo, HEADPHONE, and 3D HEADPHONE
mode.
7
Low frequency effect attenuator—LFE ATTENUATE
If the bass sound is distorted while playing back software
encoded with Dolby Digital or DTS, set the LFE level to
eliminate distortion.
Select one of the following:
0dB: Normally select this.
−−
−−
−10dB: Select when the bass sound is distorted.
Selecting main or sub channel—DUAL MONO
When the playback source is Dual Mono, you can select which,
or both channels to listen to.
Select the playback sounds (channel).
MAIN: Select to play back the main channel (Ch1).*
1
Signal indicator “L” lights up while playing back this
channel.
SUB: Select to play back the sub-channel (Ch2).*
1
Signal indicator “R” lights up while playing back this
channel.
ALL: Select to play back both the main and sub-channels
(Ch1/Ch2).*
1
Signal indicators “L” and “R” light up while playing
back these channels.
Notes:
• The Dual Mono format is not identical with bilingual
broadcasting for TV programs. So this setting does not take
effect while watching such bilingual programs.
*
1
Dual Mono signals can be heard from the following speakers—
L (left front speaker), R (right front speaker), and C (center
speaker)—with respect to the current Surround setting.
With Surround Activated
Dual Mono
Without Surround
Center speaker setting
Setting SMALL/LARGE NONE
LRLCRL R
MAIN Ch 1 Ch 1 — Ch 1 — Ch 1 Ch1
SUB Ch 2 Ch 2 — Ch 2 — Ch 2 Ch 2
ALL Ch 1 Ch 2 — Ch 1+Ch 2 — Ch 1+Ch 2 Ch 1+Ch 2
Setting the Bass Sounds
You can adjust subwoofer and bass sounds precisely according to
your preference.
7
Subwoofer output—S WFR OUTPUT
You can select the type of the signal which can be transmitted
through the subwoofer. In other words, you can determine
whether or not the bass elements of the front speaker channels
are transmitted through the subwoofer regardless of the front
speaker size setting (either “SMALL” or “LARGE”).
Select one of the following:
LFE: Select to transmit only the LFE signals (while
playing Dolby Digital and DTS software) and
the bass elements of small speakers through the
subwoofer.
LFE+MAIN: Select to always add the bass elements of the
front speaker channels (MAIN) to the above
(LFE) setting, and to transmit them through the
subwoofer.
Note:
If you have selected “NO” for the subwoofer, this function is not
available.
23-28_7032[US]f.pm6 03.3.13, 4:31 PM27