JVC LVT1007-005A Stereo Receiver User Manual


 
9
English
RIGHT
LEFT
RIGHT
LEFT
RIGHT
LEFT
+
RIGHT
LEFT
Connecting the Speakers
You can connect the following speakers:
Two pairs of front speakers to produce normal stereo sound.
One pair of surround speakers to enjoy the surround effect.
One surround back speaker or one pair of surround back speakers
to enjoy to produce more effective surround effect.
One center speaker to emphasize human voices.
One subwoofer to enhance the bass.
CAUTION:
Use only the speakers of the SPEAKER IMPEDANCE indicated by
the speaker terminals.
When connecting to both of the FRONT SPEAKERS 1 and 2
terminals, use speakers with an impedance of 16 to 32 .
When connecting to either the FRONT SPEAKERS 1 or 2
terminals, use speakers with an impedance of 8 to 16 .
Basic connecting procedure
1 Twist and remove the insulation at
the end of each speaker signal cable
(not supplied).
2 Open the speaker terminal.
For FRONT SPEAKERS 2 terminals
3 Insert the speaker signal cable.
4 Close the speaker terminal.
For each speaker (except for a subwoofer), connect the (+) and
() terminals on the rear panel to the (+) and () terminals
marked on the speakers.
Subwoofer
Speaker layout
Ideal speaker layout varies depending on the conditions of your
listening room. The diagram below is a recommended typical
example.
Right front speaker(s)
(R)
Center speaker
(C)
Surround back speakers (LSB/RSB)
Left surround
speaker (LS)
Right surround
speaker (RS)
+
RIGHT
LEFT
+
RIGHT
LEFT
Left front speaker(s)
(L)
01-14_7032[US]f.pm6 03.3.13, 4:31 PM9