Filter
Top Products
ENGLISH
50
To change the display information while
tuning in to an ensemble
Normally service name is shown on the display.
If you want to change the display information,
press D (display).
Each time you press the button, the following
information appears on the display for a while.
• Then, the display goes back to the original
indication in several seconds.
To tune in to a particular ensemble
without searching
1 Press SOURCE to select DAB tuner as
the source.
2 Press B (band) repeatedly to select the DAB
band (DAB 1, DAB 2 or DAB 3).
3 Press and hold ¢ or 4 for more
than 1 second. “MANU” or “MANUAL*” flashes
on the display.
4 Press ¢ or 4 repeatedly until the
ensemble you want is reached.
• If you hold down the button, the ensembles
keep changing until you release the button.
* When the source symbol animation display is not
selected.
Service name
&
Ensemble name
Frequency
&
Channel number
Press 4 to search
ensembles of lower
frequencies.
Press ¢ to search
ensembles of higher
frequencies.
(DAB 1)
(DAB 2)
(DAB 3)
D1
D2
D3
Within
5 Seconds
2
Select the DAB band (DAB1, DAB2,
or DAB3).
Each time you press the
button, the DAB band
changes as follows:
Note:
This receiver has three DAB bands (DAB 1, DAB 2,
DAB 3). You can use any of them to tune in to an
ensemble.
3
Start searching an ensemble.
When an ensemble is received, searching
stops.
To stop searching before an ensemble is
received, press the same button you have
pressed for searching.
4
Select a service you want to listen to.
1 Press M (mode).
2 Press ¢ or
4 to select a
service you want.
EN49_52SH909_707R[E]f.pm5 1/23/02, 5:44 PM50