Filter
Top Products
24
From the remote control:
1
Press DVD MULTI.
Note:
When you select “DVD MULTI” as the source to play, Surround
mode is canceled, and the SURROUND ON/OFF and
SURROUND MODE buttons do not work.
2
Select the analog discrete output mode on the
DVD player, and start playing a DVD.
• Refer to the manual supplied with the DVD player.
If you need to make any adjustment, go to the
following steps.
3
Press SOUND.
10 keys are activated for adjusting the sound.
4
Adjust the speaker output levels.
• To adjust the center speaker level, press
CENTER +/– (–10 to +10).
• To adjust the left rear speaker level, press
REAR•L +/– (–10 to +10).
• To adjust the right rear speaker level, press
REAR•R +/– (–10 to +10).
Using DVD MULTI Playback Mode
DVD MULTI
This receiver provides DVD MULTI Playback Mode for
reproducing the analog discrete output mode of the DVD player.
Before playing back a DVD, refer also to the manual supplied with
your DVD player.
Activating DVD MULTI Playback Mode
You can adjust DVD MULTI Playback Mode while playing back a
DVD with analog discrete output mode on a DVD player.
Once you have made adjustments, the receiver memorizes the
adjustments until you change them.
You also need to set the DVD player to the analog discrete output
mode.
Before you start, remember...
There is a time limit in doing the following steps. If the setting is
canceled before you finish, start from step
3
again.
On the front panel:
1
Press DVD MULTI.
Note:
When you select “DVD MULTI” as the source to play, Surround
mode is canceled, and the SURROUND ON/OFF and
SURROUND MODE buttons do not work.
2
Select the analog discrete output mode on the
DVD player, and start playing a DVD.
• Refer also to the manual supplied with the DVD player.
If you need to make any adjustment, go to the
following steps.
3
Adjust the speaker output levels.
1)
Press ADJUST repeatedly until one
of the following indications appears
on the display.
CENTER : To adjust the center speaker level.
REAR L :To adjust the left rear speaker level.
REAR R : To adjust the right rear speaker level.
2)
Press CONTROL UP 5/DOWN ∞
to adjust the selected speaker
output levels (–10 to +10).
3)
Repeat steps
1)
and
2)
to adjust the other
speaker output levels.
REAR R
8
9
CENTER
2
3
SOUND
CONTROL
DOWN UP
ADJUST
REAR L
56
DVD MULTI
EN24-31.RX-6020V/6022V[J]_f 3/4/02, 4:26 PM24