Filter
Top Products
37
ENGLISH
4
Select a character.
• About the available
characters, see page 47.
5
Move the cursor to the next
(or previous) character position.
6
Repeat steps 3 to 5 until you finish
entering the name.
7
Finish the procedure while the last
selected character is flashing.
To erase the entered characters
Insert spaces using the same procedure
described above. (About the available characters,
see page 47.)
Notes:
• When you try to assign a name to the 41st disc, you
cannot enter the text entry mode (and will hear a
beep sound if “Beep” has been set to “On”:see
page 33.) In this case, delete unwanted names
before assignment.
• When the CD changer is connected, you can assign
names to discs in the CD changer. These names can
also be shown on the display if you insert the discs
in this unit.
Assigning names to the sources
You can assign names to discs (both in this unit
and in the CD changer), station frequencies and the
external component.
After assigning a name, it will appear on the display
when you select the source.
Sources Maximum number of
characters
CDs* up to 32 characters
(up to 40 discs)
Station frequencies up to 10 characters (up to
30 station frequencies
including both FM and AM.)
External component up to 8 characters
* You cannot assign a name to a CD Text or an MP3 disc.
1
Select a source you want to assign a
name to.
When you select a
source, the power
automatically comes on.
2
Press and hold SEL (select) for more
than 2 seconds while pressing
DISP (D).
3
Select the character set you want
while the first character position is
flashing.
Each time you press the
button, the character set
changes as follows:
Ex.: When you select CD as the source
A – Z
(capital)
a – z
(small)
1 – 0 & Symbols
(numbers)
EN29-38LH2000[U]f.pm5 3/28/02, 14:2537