Filter
Top Products
10
ENGLISH
When an FM stereo broadcast is hard to
receive:
1 Press MODE (M) to enter the
functions mode while listening to
an FM stereo broadcast.
“Mode” appears on the display.
2 Press MO (monaural), while
“Mode” is still on the display, so
that the MO indicator is
highlighted on the display.
Each time you press MO, “Mono
On” and “Mono Off” alternately
appears.
Searching for a station manually:
Manual search
1
Select the band (FM1 – 3, AM).
Note:
This receiver has three FM bands (FM1, FM2,
FM3). You can use any one of them to listen to an
FM broadcast.
2
Press and hold ¢ or 4 until
“Manual Search” starts flashing on the
display.
3
Tune in to a station you want while
“Manual Search” is flashing.
• If you release your finger from the button,
the manual mode will automatically turn off
after 5 seconds.
• If you hold down the button, the frequency
keeps changing (in 50 kHz intervals for FM
and 9 kHz intervals for AM until you release
the button.
FM1 FM2 FM3 AM
Press ¢ to
tune in to stations
of higher
frequencies.
Press 4 to
tune in to stations
of lower
frequencies.
“STEREO” is lit when receiving an FM broadcast in
stereo.
MO indicator
MONO indicator
When the MONO indicator is lit on the
display, the sound you hear becomes
monaural but the reception will be improved.
If the sound quality decreases and the
stereo effect is lost while listening to an
FM station
In some areas, adjacent stations may
interfere with each other. If this interference
occurs, this unit can automatically reduce this
interference noise (the initial setting when
shipped from the factory). However, in this
case, the sound quality will be degraded and
the stereo effect will be also lost.
If you do not want to degrade the sound
quality and to lose the stereo effect, rather
than to eliminate the interference noise, see
“To change the FM tuner selectivity—IF
Filter” on page 33.
EN09-13LH2000[U]f.pm5 3/28/02, 14:2310