JVC CA-NXF30 Stereo System User Manual


 
62
Reference
The system supports DivX 5.x, 4.x and 3.11.
The system supports DivX files with a resolution
of 720 x 480 pixels or less (30 fps) and 720 x
576 pixels or less (25 fps).
Audio streams should conform to MPEG1 Audio
Layer-2, MPEG Audio Layer-3 (MP3) or Dolby
Digital.
The system does not support GMC (Global
Motion Compression).
Files encoded in the interlaced scanning mode
may not be played back correctly.
Playing back a DivX file may take a long time.
The elapsed time is not displayed until playback
starts. The elapsed time may also not be
displayed correctly.
The stream structure of MPEG1/MPEG2 discs
and files should conform to MPEG system/
program stream.
720 x 576 pixels (25 fps)/720 x 480 pixels (30
fps) is recommended for the highest resolution.
This system also supports the resolutions of 352
x 576/480 x 576/352 x 288 pixels (25 fps) and
352 x 480/480 x 480/352 x 240 pixels (30 fps).
The profile and level should be MP@ML (Main
Profile at Main Level)/SP@ML (Simple Profile at
Main Level)/MP@LL (Main Profile at Low Level).
Audio streams should conform to MPEG1 Audio
Layer-2, MPEG2 Audio Layer-2 or Dolby Digital
(MPEG2 files only).
The Non-DVD side of a “DualDisc” does not
comply with the “Compact Disc Digital Audio”
standard. Therefore, the use of Non-DVD side of a
DualDisc on this product may not be
recommended.
This system is compatible with USB 2.0 Full-
Speed.
This system may not play back some USB
devices and some files.
This system does not support DRM (Digital
Rights Management).
This system cannot recognize a USB device
whose rating exceeds 5 V/500 mA.
When connecting a USB device, refer also to its
manual.
Connect the USB device directly to the main unit
without routing through a USB hub.
Disconnect the USB device after stopping
playback or turning off this system.
The main unit can charge a USB device when
the USB device is selected as the source.
Always set the volume to the minimum on this
system when connecting or disconnecting a
USB device.
JVC bears no responsibility for any loss of data
on the USB device while using this system.
Notes on DivX discs/files
Notes on MPEG1/MPEG2 discs/
files
Caution for DualDisc playback
Notes on files recorded on a
connected USB device
How to attach the core filter
Attach the provided core filter to the power cable, then core filter reduces interference.
1 Release the stopper of the core filter.
2 Run the cable through the core filter, and wind the cable firmly once inside the cutout of the core filter
as shown in the illustration.
3 Close the core filter until it clicks shut.
NOTE
Do not damage the cable by applying excessive power when winding.
Power
cable
Core filter
Stopper
NX-F30[U].book Page 62 Tuesday, April 21, 2009 6:23 PM