JVC CA-NXF30 Stereo System User Manual


 
Preparation
10
To view an image on the TV screen, select the
video signal type correctly according to the TV
after connecting the main unit to the TV.
IMPORTANT
Slide the remote control mode
selector to [SHIFT].
1 Turn on the main unit.
• Refer to “Turning on/off the main unit” on
page 12.
2 Press [DVD 3] or [USB 3].
• When a disc is loaded or a USB device is
connected, press
7
to stop playback.
3 Press [SCAN MODE].
• The current video signal type appears.
Example: When “PAL.576I (Interlace)” is
selected as the video signal
4 Press 2 or 3 (cursor) to select the
video signal type suitable for the
TV.
• When the TV is connected to the [VIDEO]
terminal or the [COMPONENT] terminals,
the video signal type can be selected as
instructed below.
- Select “PAL. 576I” for a TV only compatible
with a PAL interlaced video signal.
- Select “PAL. 576P” for a TV equipped with
component terminals and compatible with
a PAL progressive video signal.
- Select “NT. 480I” for a TV only compatible
with an NTSC interlaced video signal.
- Select “NT. 480P” for a TV equipped with
component terminals and compatible with
an NTSC progressive video signal.
(Continued on the next page)
Selecting the video signal
type
Remote control
mode selector
2
/
3
(cursor)/
ENTER
NX-F30[U].book Page 10 Tuesday, April 21, 2009 6:23 PM