Filter
Top Products
55
Operating other equipment
Before the DBS operation, select the remote
control mode for the DBS.
■ IMPORTANT
• Slide the remote control mode
selector to the lowest position.
1 Press [DBS].
2 Operate the remote control by
pointing it at the DBS.
NOTE
• When the remote control mode selector is slid to
the lowest position and [DBS] is pressed, some
buttons may not work.
• It is recommended that you slide the remote
control mode selector to [AUDIO] after using this
function. Most of the other functions can be used
when the remote control mode selector is at
[AUDIO].
■ IMPORTANT
• Slide the remote control mode
selector to the lowest position.
1 Press [VCR].
2 Hold down [DBS/VCR F].
• Hold down [DBS/VCR F] until you finish
step 5.
3 Press [ENTER].
4 Press number buttons to enter the
manufacturer code.
Examples:
For a Hitachi VCR: Press [0], then [4].
For a Mitsubishi VCR: Press [1], then [3].
When the manufacturer of your VCR has 2 or
more codes, enter the manufacturer codes in
turn and find the one that operates the VCR
and the remote control properly.
The initial code setting is “01 (JVC)”.
5 Release [DBS/VCR F].
NOTE
• It is recommended that you slide the remote
control mode selector to [AUDIO] after using this
function. Most of the other functions can be used
when the remote control mode selector is at
[AUDIO].
• Manufacturer codes are subject to change
without notice. You may not be able to operate
the VCR produced by the manufacturer.
• After replacing the batteries of the remote
control, set the manufacturer code again.
Remote control button Usage
[DBS/VCR
F]
Turns on/off the DBS.
[CH +/
–
] Changes channels.
Number buttons (1-9, 0,
10)
Selects the channels.
Operating a VCR using the
remote control
Using the remote control for the
DBS operation
Setting the manufacturer code
Manufacturer Code
JVC 01, 02, 03
Emerson 11, 26
Fisher 29
Funai 10, 14, 15, 16
Gold Star 12
Hitachi 04
Mitsubishi 13
NEC 25
Panasonic 07, 17
Philips 09
RCA
05, 06
Samsung 24
Sanyo 21, 22, 23
Sharp 27, 28
Shintom 30
Sony 18, 19, 20
Zenith 08
Operating other equipment (continued)
NX-F30[U].book Page 55 Tuesday, April 21, 2009 6:23 PM