JVC CA-NXF30 Stereo System User Manual


 
11
Preparation
• When the TV is connected to the [HDMI
MONITOR OUT] terminal, the video signal
type can be selected as instructed below.
- Select “AUTO” for normal usage. (the
initial setting)
- Select “PAL. 576P”, “PAL. 720P”,
“PAL.1080I”, “PAL.1080P”, “NT. 480P”,
“NT. 720P”, “NT.1080I” or “NT.1080P” as
needed. (The selectable settings differ
according to the resolution of the
connected TV.)
• You can also select the video signal type by
repeatedly pressing [SCAN MODE].
NOTE
“480”, “576”, “720” and “1080” refer to the
number of the scanning lines. Generally, the
larger the number, the better picture that can be
obtained.
“I” refers to the interlaced scanning. “P” refers to
the progressive scanning. A better picture can
be obtained in the progressive scanning than in
the interlaced scanning.
When an HDMI video signal is output, the
“HDMI” indicator lights up in the display window.
When an HD video signal is output, the “HD”
indicator lights up in the display window.
When “PAL. 576P”, “PAL. 720P”, “PAL.1080P”,
“NT. 480P”, “NT. 720P” or “NT.1080P” is
selected, the “PROGRESSIVE” indicator lights
up in the display window.
5 Press [ENTER].
NOTE
It is recommended that you slide the remote
control mode selector to [AUDIO] after selecting
the video signal type. Most of the other functions
can be used when the remote control mode
selector is at [AUDIO].
To check the compatibility of your TV, contact
your local JVC customer service center.
Even if the main unit is turned off, the video
signal type setting is stored.
Preparation (continued)
For the locations of the remote
control buttons, refer to page 10.
NX-F30[U].book Page 11 Tuesday, April 21, 2009 6:23 PM