JVC CA-MXSK1 Stereo System User Manual


 
– 8 –
English
Connecting Other Equipment
You can connect both analog and digital equipment.
DO NOT connect any equipment while the power
is on.
DO NOT plug in any equipment until all
connections are complete.
To connect an analog component
Be sure that the plugs of the audio cords are coloured: White
plugs and jacks are for left audio signals, and red ones for
right audio signals.
For playing the other equipment through this unit,
connect between the audio output jacks on the other
equipment and AUX jacks by using audio cords (not
supplied).
Audio equipment
To audio output
AUX
IN
Voltage mark
Adjusting the Voltage Selector
Before plugging in the unit, set the correct voltage for your
area with the voltage selector on the rear of the unit.
Use a screwdriver to rotate the voltage selector so the voltage
number the voltage mark is pointing at is the same as the
voltage where you are plugging in the unit. (See the back
cover page.)
DO NOT plug in before setting the voltage selector
on the rear of the unit and all connection
procedures are complete.
127V
220V
110V
230V-240V
Now, you can plug in the AC power cord.
When connecting the AC power cord to a wall outlet, the unit
automatically starts display demonstration.
If the wall outlet does not match the AC plug, use the
supplied AC plug adaptor.
IMPORTANT: Be sure to check all connections to be done
before plugging the AC power cord into a wall outlet.
Cancelling the Display Demonstration
On the unit ONLY:
To cancel the display demonstration, press
CANCEL/DEMO during demonstration,
“DEMO OFF” will appear on the display.
When you press other buttons
The display demonstration stops temporarily. It will start
automatically again (if no operation is done for 2 minutes) unless
you cancel it by pressing CANCEL/DEMO.
To start the display demonstration manually
Press and hold CANCEL/DEMO again for more than 3
seconds.
CA-MXSK_ENUE01-12.p65 17/10/03, 9:32 AM8