Filter
Top Products
– 9 –
English
Turning On or Off the Power
To turn on the unit, press
STANDBY/ON so that the
STANDBY lamp goes off.
To turn off the unit (on standby), press
STANDBY/ON
again so that the STANDBY lamp lights up.
• A little power is always consumed even while the unit is on
standby.
To switch off the power supply completely, unplug the AC
power cord from the AC outlet.
When you unplug the AC power cord or if a power
failure occurs
The clock is reset to “0:00” right away, while the tuner preset
stations (see page 12) will be erased in a few days.
Setting the Clock
Before operating the unit any further, first set the built in clock.
You can set the clock whether the unit is on or off.
On the unit ONLY:
1
Press CLOCK/TIMER.
The hour digit start flashing on the display.
2
Press 4 or ¢ to
adjust the hour, then
press CLOCK/TIMER to
set the hour.
SET appear on display.
The minute digits start flashing on the display.
3
Press 4 or ¢ to adjust the
minute, then press CLOCK/TIMER
to set the minute. SET appear on
display.
To adjust the clock again
Make sure the ˚ (timer) indicator is not lit on the display.
• If it is lit, press and hold CLOCK/TIMER until it goes off.
If you have adjusted the clock before, you need to press
CLOCK/TIMER repeatedly until the clock setting mode is
selected.
• Each time you press the button, the clock/timer setting
modes change as follows:
When you unplug the AC power cord or if a power
failure occurs
The clock loses the setting and is reset to “0:00.” You need to set the
clock again. The clock may gain or lose 1 to 2 minutes per month. If
this happens, set the clock again.
Setting the AM Tuner Interval Spacing
Some countries space AM stations 9 kHz apart, and some
countries use 10 kHz spacing.
On the unit ONLY:
You can only change the AM
tuner interval spacing while in
STANDBY MODE.
Press
STANDBY/ON
while holding down +
/33 for 10 kHz
or –
/22 for 9 kHz interval spacing
when you change the setting.
The preset stations are erased. You will
need to preset the station again.
Common Operations
STANDBY/ON
OR
STANDBY/ON
OR
ON
OFF
TUNER
Volume setting
TAPE CD
Clock setting
OK
DAILY
TUNER
DAILY DAILY
REC