Filter
Top Products
5
Step 1: Connections
2
Connecting speakers
Important: The power cord must be connected only after all
other connections are completed.
45
78
12
9F
63
1 2
Front speakers
3
Center speaker
4 5
Surround speakers
6
Subwoofer
7 8
Surround back speakers
9 F
Height speakers
• 5.1 ch: 1 2 3 4 5 6
• 7.1 ch: 1 2 3 4 5 6 + 7 8 or
1 2 3 4 5 6 + 9 F
• Up to two subwoofers can be connected.
• To use the multi-zone function, see the section 6 "Using
the multi-zone function" of "Step 3: Playing Back".
6
Subwoofer with built-in
power amplifier
6
Subwoofer with built-in
power amplifier
5
Surround R
8F
Surround back/
height R
79
Surround back/
height L
4
Surround L
3
Center
2
Front R
1
Front L
If there is only one
surround back
speaker, connect it to
the BACK or HEIGHT
L terminal.
Important: Connectspeakerswith6Ωto16Ωimpedance.
Using a speaker with less impedance than the supported
value may result in failure. (
)
IntheAustralianmodel,itispossibletoconnectaspeakerwith4Ω
impedance.Youhavetomodifythesettingifanyofthespeakershave4Ω
ormoretolessthan6Ωimpedance.Youcansetupbyviewingtheguidance
displayed on the TV screen. Select the item with the cursor buttons of the
remote controller and press Enter to confirm your selection. To return to the
previous screen, press Return. Press RCV and then Home on the remote
controller. Select "Setup" - "2.Speaker Setup" - "Speaker Settings" - "Speaker
Impedance" and change the default value from "6ohms" to "4ohms".