Filter
Top Products
15
Step 3: Playing Back
Performing Multi-zone Playback
1.
Press Zone2 on the remote controller, point the
remote controller at the remote controller sensor
and press zReceiver.
"Z2" stays lit on the main unit display and the multi-zone
function is enabled.
2. Press Zone2 again on the remote controller and
press Input Selector of the input to be played in a
separate room.
To play the same source in the main room and separate
room, hold down Zone2 for approximately 3 seconds.
If you turn the unit to standby during multi-zone
playback, the Z2 indicator is dimmed and the playback
mode is switched to playback in a separate room only.
Performing steps 1 and 2 while the unit is in standby
also switches the playback mode to playback in a
separate room only.
To control on the main unit: Press Zone 2 and within 8
seconds, press the input selector button of the input to be
played in a separate room. To play the same source in the
main room and separate room, press Zone 2 twice.
To turn off the multi-zone function: Press Zone2 on the
remote controller and press zReceiver. Alternatively press
Off on the main unit.
To adjust the volume: Press Zone2 on the remote
controller and adjust with VOL
/
.
Alternatively press Zone
2 Level
/
on the main unit.
To mute temporarily: Press Zone2 and then press Muting
on the remote controller.
To adjust the sound quality and balance for a separate
room: Press Zone 2 on the main unit and press Tone
several times to display "Bass", "Treble" or "Balance" on the
main unit display. Display the desired setting on the display
and adjust it with + or -.
• Muting and adjustment of sound quality and balance is
not effective if "Zone 2 Out" is set to "Fixed".
• If Zone 2 is on, power consumption during standby
becomes larger than normal.
• While Zone 2 is on, the RI linked system function
(interlink between Onkyo components) is disabled.