Filter
Top Products
15
Insignia NS-HT511 Home Theater System
www.insigniaproducts.com
• When successfully joined, the power indicator
LED on your other Rocketboost device will
stop blinking and stay on.
• If joining fails after 30 seconds, the display on
your surround sound receiver shows
“Timeout.” If this occurs, repeat the above
steps.
Listening to music from other Rocketboost™ products
To listen to music:
1 Press the Power button on your surround sound
receiver to turn it on.
2 Press SETUP. The Setup Menu opens.
3 Press or to select 11. Rocketboost, then
press ENTER. The Rocketboost menu opens.
4 Press or to select Listen to Wireless
Audio, then press ENTER. The Listen to Audio
menu opens.
5 Press or to highlight the Rocketboost
device you want to listen to, then press ENTER
to select it.
Rocketboost Network Capabilities
The maximum number of Rocketboost devices in a
Rocketboost Network is nine. If you already have
nine and attempt to join an additional device,
joining will fail for the new device.
The maximum number of audio streams that can be
sent simultaneously on the Rocketboost network is
five (stereo CD quality).
Installing batteries in the remote control
To install the batteries:
1 Remove the cover.
2 Insert two AA batteries into the compartment
matching the polarity indicated.
3 Replace the cover.
Using the remote control
Use the remote control by pointing it towards the
receiver’s remote sensor window. Objects between
the remote control and sensor window may
prevent proper operation.
Setup Menu
1. HDMI Input
2. Component
3. Digital Audio
4. Sp Config
5. Sp Distance
6. Level Cal
7. Audio Adjust
8. Source Setup
9. Hardware
10. HDMI Setup
11. Rocketboost
Rocketboost
Send Wireless Audio
Listen to Wireless Audio
Connect to Wireless Network
Hub
(
Manager
)
Enable
Listen to Audio
RF-RBAUX
(
Audio In
)[
Selected
]
[
ENTER
]
to Select
Note
If you want to remove a device from your
Rocketboost network you need to rejoin it to a
different hub device (this basically creates a 2nd
Rocketboost network).
Cautions
• If the remote control doesn’t work reliably, try
replacing the batteries.
• Don’t mix new and old batteries or different
types of batteries.
• If you intend not to use the remote control for a
long time, remove the batteries to prevent
damage from leakage or corrosion.
• Remove expired batteries as soon as possible to
prevent damage from leakage or corrosion.
Batteries (AA/R6)
Approx. 16 ft. (5 m)
Receiver
Remote control sensor
NS-HT511_11-0310_MAN_.book Page 15 Wednesday, April 13, 2011 11:12 PM