Chapter 4 • Installing a J-type radio assembly
1037312-0001 Revision A
31
Chapter 4
Installing a J-type radio assembly
This chapter applies to the J-type radio assembly only. If you are
installing a cradle-type radio assembly, go to
Chapter 5 –
Installing a cradle-type radio assembly, on page 43.
This chapter includes:
• Installing a shim for vertical transmit polarization on
page 32
• Installing the radio assembly on page 36
CAUTION
• Do not remove the protective packing material from the
feed horn window until installation of the radio
assembly is complete.
• Do not remove the protective covering from the small
end of the feed horn until you are ready to attach the
waveguide transition.
• Be careful not to damage the feed horn window. Do not
touch the plastic film.