Filter
Top Products
Chapter 3 • Installing the radio and antenna assemblies
1035567-0001 Revision A
27
To connect the feed arm to the antenna reflector:
1. Insert the 5/16-18 wedge nut, thinner end first, into the slot
provided on the back of the reflector, as shown in
Figure 25.
The wedge nut is keyed so that it will fit properly only one
way into its slot in the reflector.
Make sure the hole in the wedge nut is aligned with the hole
in the reflector so you can insert the bolt. See
Figure 25.
2. Install the feed arm into the feed support socket on the
underside of the antenna reflector.
If you have the reflector turned upside down to insert the feed
arm, the orientation is the opposite of that shown in
Figure 25.
3. Use a 1/2-in. wrench to secure the feed arm with a 5/16-in.
flat washer, 5/16-in. lock washer, and 5/16-18 hex bolt. Use a
torque wrench to tighten the hex bolt from 8 ft-lbf to 10 ft-lbf.
Figure 25: Inserting the wedge nut bolt
T0145009
Antenna
reflector
5/16 - 18
hex bolt
5/16-in.
lock washer
5/16-in.
flat washer
5/16 - 18
wedge
nut
Wedge nut
Close-up view
Transmitter
Feed arm