Chapter 3 • Installing the radio and antenna assemblies
1035567-0001 Revision A
13
Assembling the Az/El
cap
The Az/El cap is shipped un-assembled. Follow the directions in
this section to assemble it. You should be able to assemble it in
about 2-5 min.
To assemble the Az/El cap:
1. Place the revolving plate on a flat surface. See Figure 8.
2. Place the polarization plate over the revolving plate.
3. Use one hand to hold the two plates together. Align the
revolving plate so its four bolt holes are visible, as shown in
Figure 9.
Figure 8: Revolving plate
Figure 9: Aligning the revolving plate