Filter
Top Products
• Important safety information
iv
1035567-0001 Revision A
Product warning labels
The following safety alert label is affixed to each side of the
satellite antenna feed arm:
This label advises that the antenna emits radio frequency (RF)
energy. Because of this potential safety hazard, observe all
cautions in the following section (
Antenna installation safety)
concerning RF radiation.
Antenna installation
safety
Observe the following precautions when installing the satellite
antenna. This manual also includes additional safety alerts where
appropriate concerning specific installation
procedures.
T0145005
CAUTION
This device emits radio frequency energy
Keep two feet (0.6 meters) away from this point
Before servicing or upgrading, unplug indoor
power connection
WARNING
Only HNS-certified installers may install or service
DIRECWAY earth stations and components. All
HNS-certified installers must expressly acknowledge the
HNS requirements for DIRECWAY installations.
DANGER
If you work on a roof, tower, or other high structure or use a
ladder or scaffold to access the work site, follow these
precautions to prevent personal injury or death:
• Walk only on sound roof structures.
• Make sure the antenna assembly and installation
surface are structurally sound so they can support all
loads (equipment weight, ice, and wind).
• Use appropriate safety equipment (for example, a
lifeline), depending on the work location.
• Follow all safety precautions from the manufacturers of
all safety equipment and other equipment used.
• Perform as many procedures as possible on the ground.