Filter
Top Products
Chapter 3 • Installing the radio and antenna assemblies
1035567-0001 Revision A
17
3. Use a 1/2-in. socket wrench or open-end wrench to loosen the
two elevation nuts. See
Figure 14.
4. Locate the elevation reference edge on the elevation scale on
the right side of the cap assembly. See Figures
14 and 15.
5. Move the canister until the elevation reference edge is at the
correct value.
Later, when you point the antenna, you fine-tune the elevation
adjustment.
6. When the edge is at the correct elevation value, tighten the
two elevation nuts.
Figure 14: Locating the elevation reference edge
Figure 15: Reading the elevation reference edge
Elevation nut
(one on each
side)
Elevation
reference
edge
Read the elevation value
at the elevation reference
edge. In this picture, the
elevation is set to 34°.