Filter
Top Products
ENGLISH
49
SETTING THE CLOCK
• Then the hour digit is flickering for several seconds.
• Each time the ENTER button is pressed, the 12 hour
display mode or the 24 hour display mode is selected.
• Then the time is displayed for several seconds and the
current operation status is displayed.
• In the power saving mode, when the CLOCK/SLEEP
button is pressed, the time is displayed for several
seconds.
• Before the time display disappears, perform the step 2.
• In case of setting the clock for the first time, perform the setting procedure from the step 2.
• In the standby mode, you can set the clock, too. In this case, perform it from the step 2.
Note :
• If the electricity fails or the AC input cord is unplugged, the current time will be cleared. Should this happen, set the clock
again, performing it from the step 2.
• Then the time is displayed for several seconds.
2. Press the CLOCK/SLEEP button for more than 2 seconds.
1. To check the time, press the CLOCK/SLEEP button for more than 2 seconds.
3. Press the CURSOR UP/DOWN ( buttons to set the hour and press the ENTER button.
4. Press the CURSOR UP/DOWN ( buttons to set the minute and press the ENTER button.
5. Press the ENTER button to select the desired time display mode.
Example ) When setting to 6:30 PM.
• Then the minute digit is flickering for several seconds.