Filter
Top Products
ENGLISH
16
• While playing the selected input source
Selecting a surround mode
• The volume level of each channel can be adjusted as desired.
Adjusting the channel level(/setting the FM mode)
• Each time this button is pressed, the surround mode
changes as follows :
(Dolby VS REF Dolby VS WIDE) or <DOLBY HP>
STEREO
( ) : Possible only when listening via the speakers.
< > : Possible only when listening via the headphones.
Surround modes
• Dolby Virtual Speaker
This mode creates a virtual surround sound field using as few as two front speakers and subwoofer, allowing you to
experience listening from 5.1 channel speakers.
* Dolby Virtual Speaker Reference("Dolby VS REF")
The width of the front sound image is defined by the actual distance between front speakers.
* Dolby Virtual Speaker Wide("Dolby VS WIDE")
The width of the front sound image seems to extend beyond the front speakers.
• Dolby Headphone("DOLBY HP")
This mode simulates 5.1 channel surround sound, which allows you to enjoy 5.1 channel surround sound through 2 channel
headphones, just like listening from 5.1 channel speakers.
• Dolby Virtual Speaker and Dolby Headphone modes are effective not only for 5.1 channel sources but also for stereo (2
channel) sources.
8. Press and hold down the SETUP button for
more than 2 seconds.
10. Adjust the level of the selected channel or set
the FM mode as desired.
11. Repeat the above steps 9 and 10 to adjust
each channel level.
• Then "Lch" is displayed for several seconds.
• When the mode display ("Lch", etc.) disappears, press
the button again.
• The channel levels can be adjusted within the range
of -10 ~ +10 dB.
• In general, we recommend the level to be adjusted to
0 dB.
• The FM mode can be set to FM STEREO or FM
MONO.
• When FM stereo broadcasts are poor because of
weak broadcast signals, set it to FM MONO mode to
reduce the noise, then FM broadcasts are reproduced
in monaural sound.
9. While displaying "Lch", press the ENTER button
to select the desired mode.
• Each time this button is pressed, the mode is selected
as follows :
Lch Rch SW ( FM STEREO)
( ) : Possible only when listening to FM broadcasts.