Filter
Top Products
20
Power on/off
Turning off the power
1.
Press the STANDBY/ON button on the projector or
the remote control.
The message "Power off?" will appear on the
screen for approximately 5 seconds.
2.
Press the STANDBY/ON button on the projector
or the remote control again while the message
appears.
The projector lamp will go off, and the POWER
indicator will begin blinking in orange. Then the
POWER indicator will stop blinking and light in
steady orange when the lamp cooling is complete.
3.
Make sure that the power indicator lights in steady
orange, and set the power switch to the OFF position.
The POWER indicator will go off. Do not set the
power switch to the OFF position while the POWER
indicator is green or blinking.
4.
Close the lens cover. For safety purposes, disconnect the power cord if the
projector is not to be used for prolonged periods of time.
• Turn the power off in right order. First power off the connected devices
and then the projector.
• Except for an emergency, whenever you turn the projector off, obey the procedure
of the following “Turning off the power”, and do not disconnect the power cord until
the procedure is completed. Neglect causes a damage of the electrode and un-
lighting of the lamp.
• This projector is controlled by an internal microprocessor. Under certain
exceptional circumstances, the projector may not operate correctly even for turning
off the power. In such a case, please push the restart switch (
6) by using a pin
or similar. After making sure that the power indicator lights to solid orange, set the
power switch to the OFF position. Only push the restart switch in these exceptional
instances.
• When a power supply is shut off with a power failure or the restart switch,
before turning on again, make the projector cool down at least 10 minutes without
operating.
NOTE
Power off?
POWER
(Blinking in orange)
POWER
(Steady orange)
POWER
(Steady orange)
Downloaded from www.Manualslib.com manuals search engine