Filter
Top Products
6
INSTALLING THE REMOTE CONTROL’S
BATTERIES
Your CD changer’s remote control requires two AA
batteries (not supplied) for power. We recommend
alkaline batteries, available from your local RadioShack
store.
l. Press in the battery compartment cover’s latch and lift
off the cover.
2. Put two fresh AA batteries into the compartment as
indicated by the polarity symbols (+ and –) marked
inside.
3. Replace the cover.
Cautions:
• Use only fresh batteries of the required size and
recommended type.
• Do not mix old and new batteries, different types of
batteries (standard, alkaline, or rechargeable) or
rechargeable batteries of different capacities.
• Always remove old or weak batteries. Batteries can
leak chemicals that can damage electronic circuits.
• If you do not plan to use the remote control for a
month or more, remove and store the batteries.
Note: If the remote’s range is reduced, replace the batteries
immediately.
USING A RECEIVER’S REMOTE CONTROL
WITH THE CD CHANGER
If your receiver/amplifier has an OSR mark, the receiver/
amplifier’s remote can control some of the CD changer’s
functions.
Plug one end of the supplied control cable into the CD
changer’s CONTROL IN jack. Plug the other end of the cable
into the receiver/amplifier’s CONTROL OUT jack.
Notes:
• This connection disables the CD changer’s infrared
sensor. Aim the remote control at the receiver/amplifier’s
infrared sensor.
• When you connect the CD changer to your receiver by
digital output only, the receiver’s remote control does
not operate your CD changer.
For details on connection and operation, refer to the
receiver/amplifier’s owner’s manual.