Filter
Top Products
16
Possible Cause
A CD is loaded backwards.
CD is dirty or scratched.
The CD changer is not correctly
connected.
The receiver/amplifier is not set to the
correct input.
The receiver/amplifier’s volume is set
too low.
A CD is loaded backwards.
The CD changer is not correctly
connected.
Interference from another electronic
device.
CD is dirty or damaged.
Too far from the CD changer.
Another device’s cable is plugged into
the CONTROL IN jack.
Weak batteries.
The control cable is not plugged in.
Audio cables are not plugged in.
Symptom
Playback stops abruptly, or the
CD changer pauses or stops
during playback.
No sound.
Sound is noisy or distorted.
CD skips.
Remote control does not work.
Receiver remote control does
not work.
TROUBLESHOOTING
This CD changer has been manufactured to the specifications of RadioShack and is covered by a limited warranty from
RadioShack. If your CD changer is not operating as it should, take it to your local RadioShack store or call 1-800-THE-
SHACK for assistance.
Your CD changer should give you years of trouble-free service. However, if you do have problems, these suggestions might
help.
FCC INFORMATION
This equipment complies with the limits for a Class B digital device as specified in Part 15 of FCC Rules. These limits
provide reasonable protection against radio and TV interference in a residential area. However, your CD changer might
cause TV or radio interference even when it is operating properly. To eliminate the interference, try one or more of the
following corrective measures:
• Reorient or relocate the receiving antenna.
• Increase the distance between the CD changer and the radio or TV.
• Use outlets on different electrical circuits for the CD changer and the radio or TV.
Consult your local RadioShack store or an experienced radio/TV technician if the problem still exists.
Suggestion
Load the CD with the label side to the left.
Clean the CD (see “CD Care Tips” on Page
15).
Recheck all connections.
Check the receiver/amplifier’s input setting.
Turn up the receiver/amplifier’s volume.
Load the CD with the label side to the left.
Recheck all connections.
Turn off nearby appliances, or use a
different AC outlet for the appliance.
Clean or repair the CD (see “CD Care Tips”
on Page 15) or try a different CD.
Move closer to the CD changer.
Use the other device’s remote control.
Replace the batteries.
Properly plug in the control cable.
Properly plug in audio cables.