Filter
Top Products
14
Programming a Sequence while a CD is
Playing
While the CD changer is playing, you can program a
sequence of tracks, but not an entire CD. Press PGM
during play, then select the CD and track using the remote
control’s number buttons and DISC SET/TRACK SET, and
press PGM. When the current track finishes playing or you
press 3, programmed play starts.
Or, you can store the track currently being played directly
into memory. While the track is playing, press PGM once
to enter the program mode, then press PGM again to store
the current track. You might find this feature convenient
to use along with hi-lite scan.
Erasing a Programmed Selection
In the program mode (when PGM appears on the display),
press CLEAR to erase the last-stored selection (track or
CD). The new last-stored selection appears on the display
until you press 6 (or 3 on the remote control).
Note: You cannot erase a selection that is currently
playing or that has already played.
Clearing a Programmed Sequence
Turning off the CD changer does not clear the
programmed sequence. To clear the sequence, do any of
the following:
• Press 7 when the CD is stopped.
• Start best selection play.
• Select ALL, SINGLE, CUSTOM, previous scan,
or play the CD in the single play slot while
programming a sequence.
• Press RANDOM while programming a sequence.
Storing a Pause within a Programmed
Sequence for Recording to Cassette
When you record a programmed sequence onto a cassette
tape, you can program a pause to occur after the last
selection you plan to record on the first side of the tape
(so you can turn the tape over).
To store a pause, press 8 on the remote in Step 3 of
“Programming a Sequence” on Page 13. PA appears on the
display.
During play, when the CD changer pauses and displays
6, turn over the tape and press 8 to resume recording.
Notes:
• You cannot program a pause as the first or last selection.
• You cannot program two pauses in a row.