Filter
Top Products
31 OPERATION
Operation
Repeat the procedure as needed until all chan-
nels requiring adjustment have been set. When
all adjustments have been made and no further
adjustments are made for five seconds, the
AVR 310 will return to normal operation.
The channel output for any input may also be
adjusted using the full-OSD on-screen menu
system. First, set the volume to a comfortable
listening level using the
Volume Control
Ó
î
. Then, press the OSD button v
to bring up the AUDIO SETUP menu
(Figure 1). Press the
¤
Button n four times
until the on-screen
›
cursor is next to the
CHANNEL ADJUST line. Press the Set
Button p to activate the CHANNEL
ADJUST
menu (Figure 8).
Figure 8
Once the menu appears on your video screen,
use the
⁄
/
¤
buttons n to move the on-
screen
›
cursor so that it is next to the channel
that you wish to adjust. Then, use the
‹
/
›
but-
tons
o to raise or lower the output level.
Remember, the goal is to have the output level
at each channel be equal when heard at the
listening position.
When all adjustments are done, press the
⁄
/
¤
buttons n to move the on-screen
›
cursor so
that it is next to
RETURN TO MENU and
then press the
Set Button p if you wish to
go back to the main menu to make other
adjustments. If you have no other adjustments
to make, press the
OSD button v to exit the
menu system.
NOTE: The output levels may be separately
trimmed for each digital and analog surround
mode. If you wish to have different trim levels for
a specific mode, select that mode and then follow
the instructions in the steps shown earlier.
6-Channel Direct Input
The AVR 310 is equipped for future expansion
through the use of optional, external adapters
for formats that the AVR 310 may not be capa-
ble of processing. When an adapter is connected
to the
6-Channel Direct Input ª, you may
select it by pressing the
6-Ch Direct Input
Selector
. The 6-Channel Direct Input may
also be selected by pressing the
Input Source
Selector
button ! on the front panel until
the words
6 CH DIRECT appear in the
Main Information Display Y, and a green
LED lights next to
6CHin the Input
Indicators
.
Note that when the 6-Channel Direct Input is in
use, you may not select a surround mode, as
the external decoder determines processing. In
addition, there is no signal at the record out-
puts when the 6-Channel Direct Input is in use.
Memory Backup
This product is equipped with a memory backup
system that preserves the system configuration
information and tuner presets if the unit is acci-
dentally unplugged or subjected to a power
outage. This memory will last for approximately
two weeks, after which time all information
must be reentered.
37
31
* CHANNEL ADJUST *
FRONT LEFT : 0dB
CENTER : 0dB
FRONT RIGHT : 0dB
SURR RIGHT : 0dB
SURR LEFT : 0dB
SUBWOOFER : 0dB
CHANNEL RESET: OFF ON
RETURN TO MENU
34