Harman-Kardon AVR 310 Stereo Receiver User Manual


 
2 TABLE OF CONTENTS
3 Introduction
4 Safety Information
4 Unpacking
5 Front Panel Controls
7 Front Panel Information Display
9 Rear Panel Connections
11 Main Remote Control Functions
14 Zone II Remote Control Functions
15 Installation and Connections
17 System Configuration
19 Input Setup
19 Surround Setup
20 Delay Settings
21 Speaker Setup
22 Output Level Adjustment
23 Manual Output Level Adjustment
25 Operation
25 Basic Operation
25 Source Selection
26 Surround Mode Chart
27 Surround Mode Selection
27 Digital Audio Playback
27 Selecting a Digital Source
29 Tuner Operation
30 Tape Recording
30 Front Panel Input/Output
Connections
30 Output Level Trim Adjustment
31 6-Channel Direct Input
32 Advanced Features
32 Display Brightness
32 Turn-On Volume Level
32 Semi-OSD Settings
34 Multiroom Operation
35 Programming the Remote
35 Direct Code Entry
35 Auto Search Method
35 Code Readout
36 Learning Codes
36 Erasing Learned Codes
36 Macro Programming
37 Programmed Device Functions
38 Volume Punch-Through
38 Channel Control Punch-Through
39 Reassigning Device Control
Selectors
40 Function List
42 Setup Code Tables
52 Troubleshooting Guide
52 Processor Reset
53 Technical Specifications
AVR 310 Audio/Video Receiver
Typographical Conventions
In order to help you use this manual with the remote control, front panel controls and rear panel
connections, certain conventions have been used.
EXAMPLE – (bold type) indicates a specific remote control or front panel button, or rear panel
connection jack
EXAMPLE (OCR type) indicates a message that is visible on the front panel information display
EXAMPLE (outlined type) indicates a lit indicator in the front panel information display
1 (number in a square) indicates a specific front panel control
¡ (number in a circle) indicates a rear panel connection
a (number in an oval) indicates a button or indicator on the remote
A (letter in a square) indicates an indicator in the front panel display
å
(letter in an oval) indicates a button on the Zone II remote