Filter
Top Products
27
5 - Help
DISC HANDLING & MAINTENANCE
DISC HANDLING PRECAUTIONS
• Hold the disc by the edges so the surface will not be soiled with fingerprints. Finger-
prints, dirt and scratches can cause skipping and distortion.
• Do not write on the label side with a ball-point pen or other writing utensil.
• Do not use record cleaning sprays, benzene, thinner, static electricity prevention
liquids or any other solvent.
• Be careful not to drop or bend the disc.
• Do not install more than one disc on the disc tray.
• Do not try to close the disc tray when the disc is not installed properly.
• Be sure to store the disc in its exclusive case when not in use.
If the surface is soiled
•Wipe gently with a soft, damp (water only) cloth.
• When wiping discs, always move the cloth from the center (if you wipe the discs
using a circular motion, circular scratches are likely to occur, which will cause noise).
• If the disc is brought from a cold to a warm environment, moisture may form on the
disc. Wipe this moisture off with a soft, dry, lint-free cloth before using the disc.
Improper disc storage
You can damage discs if you store them in the following places:
•Areas exposed to direct sunlight
• Humid or dusty areas
•Areas directly exposed to a heat outlet or heating appliance
Discs which can be played with this system:
• CD-DA
•Video-CD
• CD-R/CD-RW
• DVD
• MP3
SYSTEM MAINTENANCE
• Be sure to turn the unit off and disconnect the AC power cord before cleaning the
system.
•Wipe the unit with a dry soft cloth. If the surfaces are extremely dirty, wipe clean with
a cloth that has been dipped in a weak soap-and-water solution and wrung out
thoroughly, and then wipe again with a dry cloth.
• Never use alcohol, benzene, thinner, cleaning fluid or other chemicals. And do not
use compressed air to remove dust.