Filter
Top Products
4
DVD System User’s Guide
STEP 6 - POWER ON THE
SYSTEM
1. Connect the power cord to a standard
120VAC/60Hz electrical outlet.
• The red Standby LED will glow on
the front panel to indicate that the
system is plugged in and in Standby
mode.
2. Press the POWER button on the
front panel or the remote control to
power on the unit.
STEP 5 - CONNECT ANTENNA
AM Loop Antenna
1. Complete assembly of the supplied AM
loop antenna by rotating the base and
snapping it into place.
2. Connect the two wires from the AM loop
antenna to the AM ANTENNA connec-
tor on the back panel. Press down on
the thumb lever to insert each wire, and
then release to lock the wires in place.
FM Antenna
Connect the supplied FM antenna to the
“FM 75Ω COAXIAL” connector on the back
panel. If noise or interference occurs, use an
external antenna with a 75Ω coaxial cable
(not supplied).
Connect the
supplied AM
and FM
antennas.
Plug in and
power on the
unit.