Filter
Top Products
VOLUME
SCP 226
IR
PROJECTOR
Extron
1
2
3
4
5
6
ON
OFF
To reset, press these buttons
simultaneously while applying power.
Figure 28. Resetting the SCP 226 to Factory Defaults
Updating the Firmware
If necessary, you can replace the firmware on the SCP without
changing firmware chips. This procedure must be performed
using a computer on which the Firmware Loader software
has been installed. The RS-232 port on the computer must be
directly cabled to the RS-232 port on the SCP.
ATTENTION: Do not attempt to upload firmware if an MLC
or a System 5 IP is connected to the SCP. The
RS-232 cable from the PC must be connected
directly to the SCP.
NOTE: Each time that you replace the existing firmware, the
SCP is reset to the factory default settings.
Obtaining the Firmware Loader Program
Use the Firmware Loader program to upload a new version of
firmware to the SCP. You can obtain the Firmware Loader from
the Extron website as follows:
1. Visit the Extron website at www.extron.com.
2. On the Extron home page, select the Download tab.
SCP 104 and SCP 226 • Installation and Operation
27