Ericsson RX8200 Stereo Receiver User Manual


 
Front Panel Control
— 2.2.1 Status
2.2.1.1 Lock Status
2.2.1.2 Error Ratio/Signal Level
2.2.1.3 Modulation/FEC Rate
2.2.1.4 Standard/Spectral Sense
2.2.1.5 Pilot Symbols/Frame Size
2.2.2 Source 1 Configure
2.2.2.1 LNB Lo Frequency
2.2.2.2 Satellite Frequency
2.2.2.3 Symbol Rate
2.2.2.4 Modulation
2.2.2.5 Rolloff
2.2.2.6 Spectrum Sense
2.2.2.7 Search Range
2.2.2.8 LNB Power Op
2.2.2.9 LNB Power level
2.2.2.10 LNB 22kHz
2.2.3 Source 2 Configure
2.2.3.1-2.2.3.10 (as Source 1)
2.2.4 Source 3 Configure
2.2.4.1-2.2.4.10 (as Source 1)
2.2.5 Source 4 Configure
2.2.5.1-2.2.5.10 (as Source 1)
— 2.2.1 Status
2.2.1.1 Current Port
2.2.1.2 Encapsulation
2.2.1.3 Number of Columns/Rows
2.2.1.4 IP Packets Received
2.2.1.5 Corrected Packet Count
2.2.1.6 Lost Packet Count
2.2.1.7 Current Buffer Level
2.2.1.8 IP Jitter
2.2.1.9 TS Packets Per UDP Frm
2.2.1.10 FIFO Overflow Count
2.2.1.11 MDI Delay Factor
2.2.1.12 MDI Media Loss Rate
2.2.1.13 FEC Latency
2.2.1.14 Clear Statistics
2.2.2 Network 1 IP Address
2.2.2.1 Subnet Mask 1
2.2.2.2 Default Gateway 1
2.2.2.3 MAC Address 1
2.2.2.4 Ethernet Line Mode 1
2.2.2.5 Current Line Mode 1
2.2.2.6 RX Up Time 1
2.2.2.7 Network Utilisation 1
2.2.2.8 ICMP Enable 1
2.2.2.9 VLAN Enable 1
2.2.2.10 VLAN Tag 1
2.2.2.11 ARP Enable 1
2.2.2.12 Port 1 IGMP Version
2.2.2.13 Clear ARP 1
— 2.2.3 Network 2
2.2.3.1-2.2.3.13 (as Network 1)
— 2.2.4 Setup /MAC Mode
2.2.4.1 De-Jitter Buffer Level
2.2.4.2 SNMP Enable
2.2.4.3 FEC Enable
2.2.4.4 Network Util 1
2.2.4.5 Network Util 2
2.2.4.6 MDI Delay Factor
2.2.4.7 MDI Media Loss Rate
2.2.5 I/P Ports/ Use Input Ports
2.2.5.1 Auto Revert Delay
2.2.6 Stream 1/Unicast Enable 1
2.2.6.1 MCAST IP Address 1
2.2.6.2 Source IP Address 1
2.2.6.3 UDP Port 1
2.2.6.4 Column Port 1
2.2.6.5 Row Port 1
2.2.7 Stream 2/Unicast Enable 2
2.2.7.1 – 2.2.7.5 (as Stream 1)
— 2.2.8 Alarms/Alerts
2.2.8.1 Both Ports Lk Dn/No Data
2.2.8.2 Port 1/2 Link Down
2.2.8.3 Port 1/2 IP Conflict
2.2.8.4 Port 1/2 No Data
2.2.8.5 No Response/Out of Sync
2.2.8.6 Port 1/2 Net Util
2.2.8.7 MDI Dly Factor/Loss Rate
— 2.2.9 Version
2.2.9.1 Firmware SW Version
2.2.9.2 CPLD SW Version
2.2 I/P Input Card
2.2.1 Status
2.2.1.1 Card Alarm Status
2.2.1.2 Physical Alert Status
2.2.1.3 MPEG Alert Status
2.2.1.4 ATM Alert Status
2.2.1.5 PDH Rate/Framing
2.2.1.6 Randomizer/Stuffing Pkts
2.2.1.7 TS Packet Length
2.2.2 Setup
2.2.2.1 Mode
2.2.2.2 Destuffing/ Deinterleaver
2.2.2.3 Reed-Solomon/
Derandomizer
2.2.2.4 Man Pkt Length Ctrl/
Packet Length Size
2.2.2.5 ATM Delta/ATM Alpha
2.2.2.6 ATM Descrambling/
ATM Header Correction
2.2.2.7 ATM Header Err Ignore/
ATM VPI
2.2.2.8 Sync Cnt to Lock/
Sync Miss Sample Size
2.2.2.9 Sync Miss Limit
2.2 Configure G.703 Input
2.2 Select Satellite Input
Figure 4 Input Card Front Panel Menus
EN/LZT 790 0009 R1A 2011-03-30
20 (44)