Filter
Top Products
Quick Start Guide: Connect-Power-Configure
3 Quick Start Guide: Connect-Power-Configure
3.1 Connecting the Receiver
The following points should be noted when making signal connections to the
receiver:
• For models with option RX8200/HWO/DVBS2 fitted, connect the incoming
satellite RF feed to the rear panel connector marked RF IN 1 - 4.
• For models with option RX8200/HWO/IP/GIGE fitted, connect the incoming
MPEG Transport Stream over IP inputs to the rear panel connectors IP IN 1 -2.
• For models with option RX8200/HWO/G703 fitted, connect the incoming E3 or
DS-3 ATM inputs to the rear panel connector G703.
• If you have an incoming ASI feed, this should be connected to the ASI Input.
• Decoded PAL or NTSC video is output on connector CVBS.
• Decoded analogue or digital audio is output on connectors AUDIO OUT 1, 2, 3
or 4. Adaptor cables are used to provide the connector type required for the
installation.
• ASI OUT 1, 2 or 3 may output a Transport Stream, this can be manipulated/
generated in many ways according to the customer’s requirements. Connectors
may also be configured as SDI/HDSDI.
• For models with option RX8200/HWO/IP/OUT fitted, the incoming feed is also
routed through the unit and output on connectors IP OUT 1 and IP OUT 2.
• If the unit is to be controlled by Web browser or PC based control system then
the control PC should be connected to connector CONTROL 1 or CONTROL 2.
• If the unit is to be used to decrypt (non-Director) encrypted feeds then a
Conditional Access Module and card should be inserted in the slot labeled
Conditional Access Interface in the front panel.
3.2 Powering the Receiver
3.2.1 Switching On
Caution!
This equipment should not be operated unless the cooling fans are working and
there is free-air flow around the unit.
1. Connect all signal and power cables to the rear panel of the unit.
EN/LZT 790 0009 R1A 2011-03-30
12 (44)