Ericsson RX8200 Stereo Receiver User Manual


 
Front Panel Control
4.4 Front Panel Menus
An overview of the available Front Panel menus is shown below. The menus and
settings available will vary depending on which receiver model is being used and
which options have been enabled through the purchase of a suitable license.
Note: The menu structure is subject to change as further functionality is added.
Boot Screen
1.1.1 IP1
1.1.2 MAC1
1.1.3 IP2
1.1.4 MAC2
1.1.5 Gateway
1.1.6 Status
1.4.1 Reset All Exc IP & Reboot
1.4.2 Reset All Incl IP & Reboot
1.1 Network Menu
1.2 Build Menu
1.3 Unit Serial Number
1.4 Factory Menu
1.5 FP (Front Panel) Menu
1. System Menu
2.1 Select/Primary Input
— 2.2
1.5.1 Front Panel Lockout
3.1 Decode Service
3.1.1 Service I
3.2 Video
3.2.1 Component Selection
3.2.2 User PID
3.2.3 User STD
3.2.4 Delay Mode
3.2.5 Rx Delay
3.3 Audio
3.3.1 Audio 1
3.3.1.1 Component Selection
3.3.1.2 User PID
3.3.2-6 Audio 2-6 (as Audio 1)
3.4 SDI Embedding
3.4.1 CH 1+2: Embedding
3.4.2-3.4.8 CH3-16 Embedding (as CH 1+2)
4.1 Service Table
4.1.1 CA Summary
4.1.1.1 Service ID
4.1.1.2 - 4.1.1.24 Service ID Slots 2-24
4.2 Director V5
4.2.1 Over Air Message
4.2.2 Broadcaster ID
4.2.3 Unique Hardware ID
4.2.4 Manuf ID
4.2.5 Download Status
4.2.6 Enter New Pin
4.2.7 Reset Pin
4.2.8 Over Air Ext Carrier T/O
4.2.9 Over Air Control
4.2.10 Power Up Carrier
4.2.11 Emerg. Home Carrier
5.1 Output Selection
5.1.1 Outputs 1 and 2
5.1.2 Output 3
5.2 TS Feed Selection
6.1 Preset State
6.1.1 Preset 1 and 2
6.1.2-6.1.20 Presets 3-40
6.2 Select/Save Preset
1.2.1 SW Version
1.2.2 PS Version
1.2.3 SD FPGA Version
1.2.4 HD FPGA Version
1.2.5 Audio DSP Version
1.2.6 TS FPGA Version
1.2.7 HW ID
1.2.8 422 FW
1.2.9 422 SW
SWITCH ON
INITIALIZING
4.3.2 (Bank 0)
2. InputMenu
3. Service Menu
4. CA Systems
5. Output
6. Presets
1.1 Network Menu
1.2 Build Menu
1.4 Factory Menu
1.5 FP (Front Panel) Menu
4.2 Director Menu
See Figure 4
for Input Menus
Figure 3 Front Panel Menus
EN/LZT 790 0009 R1A 2011-03-30
19 (44)