Filter
Top Products
82
Appendix B: Notices
■
Do not place the projector where the cord can be walked on. This
may result in fraying or damage to the plug.
■
Unplug the projector from the wall outlet before cleaning. Use a
damp cloth for cleaning. Do not use liquid or aerosol cleaners.
■
Do not block the slots and openings in the projector case. They
provide ventilation and prevent the projector from overheating.
Do not operate the projector on a sofa, rug, or other soft surface,
or in a closed-in cabinet unless proper ventilation is provided.
■
Never push objects of any kind through cabinet slots. Never spill
liquid of any kind into the projector.
■
Except as specifically explained in this User’s Guide, do not
attempt to service this product yourself. Refer all servicing to
qualified service personnel. Opening or removing covers may
expose you to dangerous voltages and other hazards.
■
Unplug the projector during lightning storms or when it will not
be used for extended periods.
■
Do not place the projector and remote control on top of
heat-producing equipment or in a hot location.
■
Unplug the projector from the wall outlet and refer servicing to
qualified service personnel under the following conditions: When
the power cord or plug is damaged or frayed. If liquid has been
spilled into the projector, or if it has been exposed to rain or
water. If it does not operate normally when you follow the
operating instructions, or if it exhibits a distinct change in
performance, indicating a need for service. If it has been dropped
or the housing has been damaged.
■
If you use the projector in a country other than where you
purchased it, use the correct power cord for that country.
■
Do not stand on the projector or place heavy objects on it.
■
Do not attempt to remove the lamp immediately after use. Allow
the lamp to cool for approximately one hour before removing it.
■
Do not use the projector outside of the required temperature
range (41 to 95 °F). Doing so may cause an unstable display and
an excessive load on the fan, leading to projector damage.