Filter
Top Products
Using the Projector
25
Shutting Down the Projector
When you’ve finished using the projector, follow the recommended
procedure to shut it down. This extends the life of the lamp and
protects the projector from possible overheating.
1. If you’re using a computer, shut it down first.
2. To turn off the projector, press the red
Power
button on the
projector or remote control. You see a confirmation message. (If
you don’t want to turn it off, press any other button.)
3. Press the
Power
button again. The power light flashes orange for
about a minute as the projector cools down. When the projector
has cooled, the orange light stays on and the exhaust fan shuts off.
If you want to turn the projector on again, wait until the orange
light stops flashing. Then press the
Power
button.
4. Replace the lens cap, retract the lens, and unplug the power cord.
5. If you’re using a VCR or other video source, turn it off after you
turn off the projector.
6. Disconnect all equipment, and store the projector in the bag that
came with it or in a protective case.
note
When the projector has not
received any input signals for
3
0 minutes, it automatically
turns off the projector lamp
and enters “sleep mode.” This
conserves electricity, cools the
p
rojector, and extends the life
of the lamp. If you are done
using the projector, unplug
the power cord. If you want
to start projecting again, press
the
Power
button.
power light
Power
button
caution
To avoid damaging the
projector or lamp, never
unplug the power cord
when the power light is
green or flashing orange.