Filter
Top Products
20
5.) Close the front panel. The disc will spin and zeros will flash in the track number
and time display. Within a few seconds the disc will stop spinning and the
display will show the total playing time and total tracks on the disc.
Note: If the disc is inserted upside
down or if the disc is badly scratched
and unreadable, playback will not be
possible. In this case the main display
will show “dISC no”. Remove the disc
and re insert it properly, or try another
disc.
6.) Press the PLAY/PAUSE button on
the front panel of the main unit or on
the remote control to begin playback on
track 1. The display will show the
elapsed playing time of each track as it
plays.
7.) Adjust the VOLUME controls as desired.
8.) When the last track has played the
player stops automatically and the
display again shows the total playing
time and tracks on the disc. You may
also stop playback at any time by
pressing the STOP/BAND button on
the front panel of the main unit or on
the remote control.
9.) When you are finished listening tilt the front panel forward, remove your disc
and close the front panel again.
10.)Press the POWER/STANDBY button to return the system to the Standby
(Power Off) mode.
ES88_ib072503.p65 25/7/2003, 10:0920