Filter
Top Products
30 Micro Motion
®
Model 2400S Transmitters
I/O Wiring – Model 2400S PROFIBUS-DP and DeviceNet Transmitters
4.4 I/O wiring for Model 2400S DeviceNet transmitters
Connect the transmitter to the DeviceNet segment according to the diagram in Figure 4-3. The
transmitter is shipped with a DeviceNet male sealed Micro Connector (Eurofast) that has been
preinstalled and wired according to the DeviceNet specification.
Follow all local safety regulations.
Figure 4-3 Model 2400S DeviceNet I/O wiring
WARNING
A transmitter that has been improperly wired or installed in a hazardous area
could cause an explosion.
To avoid the risk of an explosion:
• Make sure the transmitter is wired to meet or exceed local code requirements.
• Install the transmitter in an environment that complies with the classification tag
on the transmitter. See Appendix A.
➯
Attach a 5-pin female
Eurofast connector here