Filter
Top Products
Basic Setup
04
37
En
Chapter 4:
Basic Setup
Switching the speaker impedance
We recommend using speakers of 8 Ω with this system,
but it is possible to switch the impedance setting if you
plan to use speakers with a 6 Ω impedance rating.
1 Switch the receiver into standby.
2 While holding down
ENTER
on the front panel,
press
STANDBY/ON
.
The display shows RESET NO .
Use TUNE / (or / on the r emote control) to select
SPEAKER 8Ω , and then use PRESET / (or /
on the remote control) to select SPEAKER 8Ω or
SPEAKER 6Ω.
• SPEAKER 8Ω – Use this setting if your speakers are
rated at 8 Ω or more.
• SPEAKER 6Ω – Use this setting if your speakers are
rated at 6 Ω.
Changing the OSD display language
(OSD Language)
The language used on the Graphical User Interface
screen can be changed.
•The explanations in these operating instructions are
for when English is selected for the GUI screen.
1 Switch on the receiver and your TV.
Make sure that the TV’s video input is set to this receiver
(for example, if you connected this receiver to the VIDEO
jacks on your TV, make sure that the VIDEO input is now
selected).
2 Press on the remote control, then press
HOME MENU
.
A Graphical User Interface (GUI) screen appears on your
TV. Use /// and ENTER to navigate through the
screens and select menu items. Press RETURN to exit
the current menu.
3 Select ‘
System Setup
’ from the
Home Menu
.
4 Select ‘
OSD Language
’ from the
System Setup
menu.
5 Select the desired language.
6 Select ‘
OK
’ to change the language.
The setting is completed and the System Setup menu
reappears automatically.
Automatically conducting optimum
sound tuning (Auto MCACC)
The Auto MCACC Setup measures the acoustic
characteristics of your listening area, taking into account
ambient noise, speaker connection and speaker size, and
tests for both channel delay and channel level. After you
have set up the microphone provided with your system,
the receiver uses the information from a series of test
tones to optimize the speaker settings and equalization
for your particular room.
Important
•Make sure the microphone and speakers are not
moved during the Auto MCACC Setup.
• Using the Auto MCACC Setup will overwrite any
existing settings for the MCACC preset you select.
•Before using th
e Auto MCACC Setup, the
hea
dphones should be disconnected.
CAUTION
• The test tones used in the Auto MCACC Setup are
output at high volume.
THX
®
•THX is a trademark of THX Ltd., which may be
registered in some jurisdictions. All rights reserved.
1 Switch on the receiver and your TV.
Make sure that the TV’s video inp ut is set to this receiver.
2 Connect the microphone to the
MCACC SETUP MIC
jack on the front panel.
Make sure there are no obstacles between the speakers
and the microphone.
RECEIVER
MASTER
VOLUME
MCACC SETUP MIC
USB
iPod
iPhone
VIDEO
CAMERA
HDMI 5
CONTROL ON
/
OFF
Microphone
Tripod
VSX-33_UXJCB.book 37 ページ ２０１０年３月９日 火曜日 午前１０時３９分