33
Programming the Remote
Programming the Remote to Control an
RCA brand DSS
®
Receiver
The remote is preprogrammed to control the RCA DSS
®
receiver. A few of the remote buttons used with the RCA DSS
®
receiver are shown below. You may want to experiment with
other buttons on the remote to see if they work with
your receiver.
Receiver Remote (works like) RCA DSS
®
Remote
INFO SELECT/DISPLAY
GO BACK PREV CH
ANTENNA TV/SAT
CLEAR CLEAR
MENU/SELECT MENU
MOVE ARROWS ARROWS
Programming the Remote to Control A
Satellite receiver
1. Turn on the satellite receiver.
2. Look up the satellite receiver brand and
corresponding code number(s) in the code list on
the right.
3. Press and hold the SAT•CABLE button on
the remote.
4. Enter the three-digit code from the code list.
5. Release the SAT•CABLE button, then press POWER
or CH + or CH – to see if the receiver responds to
the remote commands. If it doesn’t, try pressing
SAT•CABLE, then POWER again.
6. Repeat steps 3 through 5 using the next code listed
for the brand of your receiver until the receiver
responds to the remote commands.
This remote may not operate all
models of the brands shown.
SATELLITE Receiver Codes
Chaparral ............................. 080, 081
Cheyenne ..................................... 081
Drake.................................... 082, 083
RCA DSS
®
System ........................ 000
General Instruments . 092, 093, 094
RCA ............................................... 000
Realistic........................................ 084
Sierra I,II,III .................................. 081
STS1 .............................................. 085
STS2 .............................................. 086
STS3 .............................................. 087
STS4 .............................................. 088
Toshiba......................................... 089
Uniden ......................................... 090
Video Cipher II ............................ 091
DSS
®
is a registered trademark of DIRECTV, INC.,
a unit of Hughes Electronics Corporation.