Filter
Top Products
32
Programming the Remote to Control a
Laserdisc Player
You may be able to program your remote to control a
laserdisc player. Use the codes shown to the right or on the
sheet packed with your remote.
Follow these steps to program your remote to control your
laserdisc player:
1. Turn on the laserdisc player.
2. Look up the brand and its code number(s) in the
code list.
3. Press and hold the LD•VCR2 button on the remote.
4. Enter the three-digit code from the code list.
5. Release the LD•VCR2 button, then press POWER to
see if the laserdisc player responds to the remote
commands. If it doesn’t, try pressing LD•VCR2, then
POWER again.
6. Repeat steps 3 through 5 using the next code listed
for your brand until the laserdisc player responds
to the remote commands.
PROGRAMMING THE REMOTE TO CONTROL A
DVD PLAYER
The remote is preprogrammed to control a RCA DVD player. A
few of the remote buttons used with a DVD player are shown
below. You may want to experiment with other buttons on
the remote to see if they work with
your DVD player.
Receiver Remote (works like) DVD Remote
INFO INFO
GO BACK GO BACK
CLEAR CLEAR
MENU SELECT MENU SELECT
MOVE Arrows ARROWS
PLAYLIST PLAYLIST
ENTER ENTER
Laserdisc Player Codes
Pioneer................................. 033, 037
ProScan ................................ 033, 037
RCA ....................................... 033, 037
Programming the Remote
This remote may not operate all
models of the brands shown.