Filter
Top Products
28
Programming the Remote to Control
a VCR
To determine whether you need to program the remote,
turn on the VCR, point the remote at the VCR’s remote
sensor, and press VCR. Then, press the POWER or CH +
or CH – button to see if the VCR responds to the remote
commands. If not, you need to program the remote.
Follow these steps to program your remote to control
your VCR:
1. Turn on the VCR.
2. Look up your VCR brand and code number(s)
in the code list on the next page or on the
code sheet packed with your remote.
3. Press and hold the VCR1 button on
the remote.
4. Enter the three-digit code from the code list.
5. Release the VCR button, then press POWER to
see if the VCR responds to the remote
commands. If not, try pressing VCR
then POWER.
6. Repeat steps 3 through 5 using the next code
listed for your VCR brand until the VCR
responds to the remote commands.
Programming the Remote
This remote may not operate all
models of the brands shown.
To program the LD•VCR2 button
to control a second VCR, follow
these steps but use the
LD•VCR2 button instead of the
VCR button.