Filter
Top Products
IMPORTANT
Switch off the power before connecting speakers and other equipment.
SPEAKER CORD CONNECTION
Connect the wires with the printed white lines to the red (+) terminals and the
plain-black wires to the black (-) terminals.
NOTE:
Connecting speakers other than the speakers supplied with the unit, may
damage the unit.
Main Speakers (Left and Right)
Speakers should be placed beside the audio system left and right side several feet apart. Do not place them too close to
a colour television as they could cause incorrect colour to appear on the picture.
Surround (Rear) Speakers (Left and Right)
Speakers should be placed behind and aimed toward the viewing area.
Centre Speaker
Speaker should be placed between two main speakers at the top of audio system.
NOTE: Centre speaker is magnetically shielded.
Main Speakers (Left and Right)
Centre Speaker
-LT "'U
[:JD
o
I
m
o~
I
E
1~~
-<:::
To External
Source
9
To AC Outlet
CONNECTION WITH OTHER OPTIONAL
EQUIPMENT
To listen to or record audio signals from external units
through this unit:
Connect the red plug to the R jack, and the white plug to
the L jack to the AUX IN connector.
Dolby Pro logic surround sound can only be reproduced
from a stereo sound source, such as a NICAM television,
NICAM video recorder, stereo video disc play or stereo
satellite receiver. Some older kinds of stereo equipment
will not work properly with Pro logic sound recorders.
LISTENING TO THE CONNECTED EQUIPMENT
1. Press the FUNCTION button to AUX.
2. Play the external source.
Note: II the external equipment is a television and this audio system is close to it, you may experience interference if the
tuner function is selected while the television is working.
CAUTION:
.FOR U.S.A. AND CANADA
To prevent electrical shock, match wide blade of plug to wide slot, fully inser1.
.Be sure the AC power cord is disconnected and all functions are off before making onnections.
TO TURN ON THE UNIT
Press the POWER bu"on. The display will light up. Select the desired function and the corresponding function indicator
will light up.
AFTER USE
Press the POWER button to enter STANDBY. The display light will fade and only the clock display will be shown.
E-3