Filter
Top Products
ENGLISH
24
13
RELAY MODE
★ Various types of playback and recording can be performed through relay operation between the set’s CD and CD-R units.
★ There are three relay modes.
★ The set mode is stored in the memory, but the data may be cleared if the power is not turned on for 2 or 3 days.
• The mode switches as shown below each time the RELAY MODE button is pressed.
Relay mode
ª
ª
ª
• The disc in the CD unit and the one in the CD-R
unit are played one after the other.
• Programmed play and random play of the disc in
the CD unit and the one in the CD-R unit can be
performed as if the two discs were a single disc.
• The CD and CD-R units can be operated
independently.
• Either the CD or the CD-R unit can be operated.
Relay mode:
Mix mode:
Dual mode:
Normal mode:
ª
“Relay Play”
“Mix Play”
“Dual Play”
“Single Play”
8. Timer playback
• A separately sold audio timer can be used to start playback or recording at a specific time.
• Also refer to the operating instructions for the audio timer and amplifier.
• The program and relay modes can also be used.
Timer playback
STOP
PAUS E
PLAY
2
4
3
78
56
1
9
10
+
10
REC
_
DUBBING
_
NORMAL HIGH
RELAY
MODE
CD CD-R
ENTER
MENU
8
9
3
2
6
7
PROG/DIRECT
CALL
RANDOM
1 / ALL A - B
CHARACTER
TIME
TITLE
M
+✽ –
CLEARCLEAR
A ! "
J
( )
D # % G & '
P
,
Y
< < >
V
:
;
S
.
[ = ] {
?
}
OPEN / CLOSE
TIME
TIME
CLEAR INPUT
MENU
5
OPEN /CLOSE
5
PROFESSIONAL CD RECORDER DN-C550R
PHONES PHONES LEVEL
MIN
MAX
POWER
ON
OFF
FINALIZE
MULTI JOG
3
1
2
3
1
2
REMOTE SENSOR
PLAY STOP PAUSE
HIGHNORMAL
DUBBING
8
9
RELAY MODE
DISPLAY
SELECT
TITLE /
CHARACTER
PUSH
ENTER
8
9
PLAY STOP PAUSE
4
REC
-
+
5 5
1
(Main unit)
(Remote control unit)
1
Turn on the power of the DN-C550R and the connected components.
3
Load the Disc for timer playback into the DN-C550R.
4
Set the amplifier's input selector to “CD”.
5
Press the play button (1 PLAY).
• Play the disc to check the volume.
2
Perform the procedure at “Setup Method (10) Timer play mode setting” (Page 13) and make the timer playback on
setting.
6
Set the audio timer for the desired time.
• The power of the components connected to the audio timer turns off.
• When the set time is reached, the power of the various components turns on automatically and playback begins from
track one.
Select the deck to be operated.
• The settings for the program mode, random mode, relay mode, etc., are stored in the memory before the power is turned
off.
• If there is no disc in the CD side and a disc is loaded in the CD-R side:
Timer playback does not function when the relay mode is set to normal or dual.
Timer playback functions for the CD-R side when the relay mode is set to relay or mix.
NOTE:
• Recording, finalizing and editing are not possible in the relay or mix mode.