Filter
Top Products
ENGLISH
13
9
COPYING PROCEDURE
About copying
★ Copying can be performed easily from the set’s CD unit onto the CD-R unit.
★ There are two copying speeds (normal and high) and four copying modes.
• The mode switches as described below each time the normal speed copying button (NORMAL) or the high speed copying
button (HIGH) is pressed.
• The recording level is automatically set to the default value (0.0 dB).
• The repeat and random play modes are canceled when the copy mode is set.
• During normal speed copying you can listen to the sound as you copy.
• During high speed copying no sound is produced.
• No signals are output from the digital outputs during high speed copying.
• During copying, buttons other than the CD or CD-R stop buttons do not function.
• When CD TEXT compatible CDs are copied, the disc names and track names are also copied.
★ When copying, switch the relay mode to the normal or dual mode. Copying is not possible in the relay or mix mode.
Relay mode Relay Mix Dual Normal
Copying ✕✕❍❍
★ For optimum recording, make sure there are no fingerprints, scratches or dust on the signal surface of the source side CD or
the CD-R/RW.
★ The auto track function is always activated in the copying mode. It is not possible to assign track numbers manually.
(See page 6.)
Disc dubbing: Entire CDs or programmed tracks can be recorded onto a CD-R/RW.
(“All Tr Dubb” is displayed.)
Make CD: Entire CDs or programmed travks can be copied onto a CD-R/RW then finalized automatically.
(“Make CD Dubb” is displayed.)
1TR dubbing: In this mode, single tracks on CDs can be copied.
(“1Tr Dubbing” is displayed.)
Scan REC dubbing: In this mode, the desired tracks can be selected from CDs and copied.
(“Scan Rec Dub” is displayed.)
ª
ª
ª
ª
NOTES:
• Digital copying may not be possible due to SCMS restrictions if “SCMS ENA” is set at “Copy management” in the setup
mode. In this case, copying is automatically performed at normal speed and using analog signals. (See page 6.)
• Analog signal copying is always performed in the normal speed mode.
• If when the copying mode is set the recordable time on the CD-R/RW is shorter than the time of the CD source you are
trying to copy, “CD-R Short” is displayed and both the CD and CD-R units are set to the stop mode. If this happens,
check the disc’s recordable time. (However, when recording track numbers 21 or higher from a source CD containing
over 20 tracks, “CD-R Short” may not be displayed even if the source time you want to record is longer than the
recordable time on the CD-R/RW.)
• If the disc name has already been input on the disc on which you are recording, only the track names are copied.
• For some CDs, the text cannot be copied because of copyright protection. In this case “Text Protect” is
displayed.
• Do not turn off the power or unplug the power cord while “Now PMA Rec” is displayed after recording is completed.
Doing so may render the disc unusable.
(11) Copy management
★ Serial copy management on/off selection. (See page 6 for a description of SCMS.)
1
Set the unit to the setup mode, then turn the jog dial of the main unit or press the automatic search button of the
remote control to display “SCMS Set?”.
2
Press the enter button and set the copy management.
3
Turn the jog dial on the main unit or use the automatic search buttons on the remote control unit to turn the copy
management.
• The selected mode indication will flash. “ENA./INH.”
4
Press the enter button to set the copy management.
•“SCMS ENA.” or “SCMS INH.” will be displayed.
STOP
PAUS E
PLAY
2
4
3
78
56
1
9
10
+
10
REC
ENTER
MENU
8
9
3
2
6
7
PROG/DIRECT
CALL
RANDOM
1 / ALL A - B
CHARACTER
TIME
TITLE
M
+✽ –
CLEARCLEAR
A ! "
J
( )
D # % G & '
P
,
Y
< < >
V
:
;
S
.
[ = ] {
?
}
OPEN / CLOSE
TIME
TIME
CLEAR INPUT
MENU
5
OPEN /CLOSE
5
PROFESSIONAL CD RECORDER DN-C550R
PHONES PHONES LEVEL
MIN
MAX
POWER
ON
OFF
FINALIZE
MULTI JOG
3
1
2
3
1
2
REMOTE SENSOR
PLAY STOP PAUSE
HIGHNORMAL
DUBBING
8
9
RELAY MODE
DISPLAY
SELECT
TITLE /
CHARACTER
PUSH
ENTER
8
9
PLAY STOP PAUSE
4
REC
-
+
1,2,3,4
2,4
1,3
(Main unit) (Remote control unit)
NOTES:
• SCMS INH: Digital recording is possible without this restriction even if the recording source contains a copy prohibit
code, but in this case the copy prohobit code is written on the recorded disc. In addition, a copy prohibit
code is writen on the recorded disc even if the recording source does not have a copy prohibit code.
• SCMC ENA: Inkeeping with SCMS, digital recording is not possible if the recording source contains a copy prohibit code.
Final Tr
Final Tr
10s
-54dB
2Tr1Tr
2Tr1Tr
Source
CD-R/RW disc
-54dB
• Digtal dubbing
Final Tr
Final Tr
10s
3s
-54dB
2Tr1Tr
2Tr1Tr
Source
CD-R/RW disc
Synchro Level
• Analog signal dubbing